Vigilancia tecnológica

In this study, we present a computer model of starve fed single screw extrusion of wood plastic composites (WPC). Experimental studies have been performed on the extrusion of the polypropylene (PP) based composites with various wood fiber contents (WF). The melting mechanisms of the composites in the extruder have been observed, and melting models have been proposed for partially and fully filled sections of the screw. It was observed that in the partially filled section the material is melted by conduction, as in the case of extrusion of neat polymers. On the other hand, in the fully filled section, the Tadmor melting mechanism appears, which is different compared to the melting mechanism of neat polymers at starve fed extrusion, where dispersed melting is observed. Using the melting models, the global computer model of the process has been developed which makes it possible to predict the process flow, i.e., the polymer melt temperature and pressure, the polymer melting rate, and the degree of screw filling. To build the model, the specific forward/backward procedure was developed, which consists in determining “forward” the melting profile, and “backward” the pressure and screw filling profile. The temperature profile in the melting section is computed “forward”, while “backward” in the metering section. This procedure makes it possible to solve the crucial problem of modeling of the starve fed extrusion process, which is to find the location of the point where the screw is fully filled, and the pressure is developed. The model has been tested by pressure measurements in the extruder.